* Please note
that listings may close after their originally scheduled end time,
as the end time resets to two minutes from the time a bid is placed
whenever less than two minutes remain. See the "Soft Close"
section of the
How to Bid page for details.
Anycubic Kobra Auto Leveling FDM 3D Printer - 220MM x 220MM x 250MM Build Volume
Bidders are responsible for conducting their own
product research.
Item condition:Previously handled/used - with issue (see notes)
Package condition:No packaging or repackaged
Condition notes:Item has some light scuffs/scratches from previous use. There appears to be 2 nozzle heads, one is fine and functional while the other was clogged with filament. We were able to heat up the nozzle and clean it off, however we have not tested it for its stability. It may need a PID tune. Bed and the other nozzle heats up normally. All axis" are functional. Please review photos
*GENERIC CONDITION STATEMENT* Item has been handled/inspected by our staff to the best of their ability/knowledge and a noticeable issue has been found. This can be a minor piece missing, a major piece missing or a defect with the item that we deem is still worth listing as the item is still functional - Please read above ours notes and view any photos attached
Payment & pick-up deadline:Saturday September 28th at 5:00 pm